Introduction
This listing is for a new boat, built to order from the Leonardo Yachts factory in Sneek, The Netherlands. These stunning boats are highly customizable, so please reach out with any questions you have.
The entire deck is finished with teak.
Most forward there is the anchor locker with a flush deck hatch. Optional you can
choose for an electric anchor winch, this means the anchor has to be lifted
manually with custom stainless steel anchor arm over the side. (half of the weight
is carried by the hinge). Now the anchor can be dropped or taken up using the
powered Lewmar windlass. When the anchor is stowed there is room for 2-3
fenders.
Behind the watertight bulkhead the double bed is situated. The cabin has 2 little
seats and a locker on each side. The electric operated toilet is located on
starboard while the main control panel is located port side convenient next to the
entrance. Under the seats in the cabin and in the step to the cabin there is
further storage space. The interior space is limited however sufficient for a nice
overnight stay or weekend trip.
Deck and Hull
Foam-core epoxy hull laminate, finished in an offwhite gel coat
Foam-core epoxy laminate superstructure finished in a white gel coat (RAL 9001)
Integrated recessed cove line in the hull
Below the waterline epoxy primers and barrier coat finished with white or black
antifouling
- Inside of hull / bilges painted white
- High performance modern T-bulb fin keel.
- Stainless steel construction, GRP fin fairing, lead bulb
- 8 mm teak deck
- Flush teak anchor locker hatch with gas spring
- Below deck mounted jib furler (manual, or optional electric)
- Large aft lazerette, hatch with gas spring
- 4 stainless steel pop-up mooring cleats incl stainless steel hull protection strips
- Fittings for gennaker blocks
Cockpit
- Self bailing with teak flooring
- Benches / cockpit lockers finished in teak
- Varnished mahogany capping rail on the cockpit coaming
- Luxurious mahogany cockpit table with sink, tap and storage possibilities
- Edson steering pedestal finished with mahogany compass rim
- Stainless steel 7 spoke steering wheel with mahogany rim
- Stainless steel Ritchie compass with light
- 4 cockpit lockers
- Refrigerator in cockpit table
- Exclusive Sunbrella upholstery, colour by choice
Cabin
- Double V-shaped bed (length 218 cm, 150 cm wide at head, 75 cm at feet end)
- Mahogany interior matt varnished
- Flooring finished in teak
- Ceiling finished in off white alcantare fabric
- 2 cupboards
- Custom Leonardo Yachts stainless steel switchboard panel
-Varnished mahogany finished seats with storage space inside
- Walls and bilges painted in Ral 9001
- Halogen lights with dimmer in saloon
- 2 x bed side reading lights
- Flush deck hatch
- Electric toilet
Sails and Rigging
- Self tailing halyard winch, Lewmar or Harken 40 black
- 2 x self tailing jib sheet winches, Lewmar EVO 45 black or Harken 46
- Electric captive mainsheet winch (below deck), Lewmar CW800
- Aluminium mast and boom, painted white (Ral 9001)
- Dyform 6mm shrouds
- 6mm fixed backstay, with trimming blocks lead to cockpit
- 2 spreaders sets, 1 jumper spreader set
- Hydraulic boom vang
- Hydraulic backstay tension cilinder
- Flush mounted manual Genua-furler Furlex TD 200 mm with tensioner
- Windex
- 2 Antal Stainless steel genua tracks with cars
- 2 stainless steel Antal jib sheet pad blocks
- 5 Spinlock stoppers
- Lazy-jack system
- North Sails NPC cross-cut Nordac, mainsail 39.3 m2, furling jib 100% 30,9 m2.
- Mainsail cover
- All necessary halyards, sheets and lines
Mechanical
- Volvo Penta D1-20 hp saildrive
- Motor panel in cockpit
- Level indicator for water tank, waste tank and fuel
- 12 V electrical system including Ah measurement
- Batteries: 2 x 200 Ah AGM, 1 high power start battery
- 2 x automatic bilge pumps
- 1 x Manual bilge pump
- Shore power and battery charger by Mastervolt
- 3 x AC sockets. 110 or 220 Volt
- Navigation lights; 3-colour top, anchor, steam, stern and red/green bow light
- Deck light
