This classic is one of only five ever made 60 foot Mathews Cruisers and the last and only good one left in the world.
Artania II, a 1970 60’ Cruiser build by the Matthews Boat Company in Port Clinton, Ohio, is the last of the wood-hulled Matthews boats built before the company began building fiberglass boats in 1971. Formerly known as "Mahogany", the Matthews was owned by a Michigan congressman, and was a familiar sight to many cruising the Great Lakes every summer.
Artania II was purchased by her current owner at Mertaugh Boat Works during the winter of 2011. That spring some new planks were installed in time to launch for the owner to enjoy a trip to Mackinac Island as well as win 1st Place in the Les Cheneaux Antique Wooden Boat Show, the third time she would receive that honor.
During the winter layup of 2012 plans were made to replace more hull planks, and beautiful new teak decking was milled and installed while the hull planks were being replaced.The deckhouse was refurbished as well. Also a custom-designed and fabricated teak bench seat was built for the bow deck area, providing additional seating and storage. All bright work was sanded and varnished to show-quality specs, and the hull was primed and painted.
The yacht underwent a major electronics upgrade including the installation of two complete navigation systems while making extensive upgrades to the interior wiring and electrical systems onboard.
In August of 2014, Artania II headed south, and she is currently cruising the waters of South Florida
“Artania II” has just recently undergone more wood planking replacement on the underwater areas. This work has been well documented with photographs. Please request these photos if required. The company that carried out these repairs is Gillen Diesel and Marine Services at Harbour Towne Marina in Dania Beach Florida. As well as new bottom planking, a new 17.5 Kw Phasor Generator, New AGM Batteries, Mastervolt Battery Charger and Magma Energy Inverter were installed, as well as many other upgrades including some electrical upgrades. New 12 volt “gulper” bilge pumps were added to the machinery space.
There has been no expense spared in the care and upgrades to the vessel “Artania II”.
DETAILS & DIMENSIONS
Speed / Weight
Hull & Deck
Coast Guard #:
Guest SR/S: 3/0
- Crew R/B/S: 0/0/0
60' 0" (18.29m)
16' 0" (4.88m)
4' 0" (1.22m)
4' 0" (1.22m)
Cruise Speed RPM:
Cruise Speed Range:
Max Speed RPM:
Max Speed Range:
GENERATOR AND ELECTRICAL
Phasor 17.5kw newly installed with 20 hrs.
Receptacles: 2 x 250 volt x 50 Amp
Power cords: 1 x 250 volt x 50 Amp + 1 x 125 volt x 50 Amp
Power cords: 2 x 125 volt x 30 Amp
Battery installation: 4 x 12 Volt AGM forward to starboard in engine room
12 Volt chargers: 50 Amp “Mastervolt”
Inverter: “Magma Energy”
Inverter charger: 60 Amp
All batteries AGM sealed type in Wood boxes
Battery switches: Four approved type
Air conditioning: Cruise Air
Heating: Reverse cycle in the above + electric floor level heaters
Phone / TV recep.: Yes
Lights: 12 volt DC & 110 volt AC
Bonding system: Throughout
Engine rm. blowers: 12 volt DC
Compass: 10” Ritchie Auto Pilot: Garmin Radar: Garmin 7215 72 Mile GPS: 2 x Garmin 7215 Chart plotter: In above GPS’s VHF: Garmin VHF 200 Hailer: In VHF radio Speed log: In GPS’s Depth finder: Garmin GMI 10 multi CCTV system: Yes w/ cameras in engine room, aft deck & salon
Location of galley: Forward down to port Location of dinette: Opposite galley to starboard + helm deck table Stove top: 4 Burner “General Electric”, electric Microwave: “General Electric” Convection oven: In the above microwave oven Refrigeration: “Marvel” Freezer: As above Icemaker: On helm deck Hot water heater: 30 gallon “Kenmore”, electric Washer / Dryer: “Ariston” two piece
Built in system: “Kidde”
Type: 2 x 35 lb. Co2 bottles
Tank location: In engine room
Automatic release: Yes
Manual release: At helm
Hand held: 4 x 2 ½ LB. & 1 x 10 lb. Dry powder
Aux. fire pump: 12 volt deck wash downs
Dewatering pumps: 4 x 12 volt submersible type w/ float switches + 4 x 12 volt dry
out Gulper pumps